Skip to content

Session 4: Controllers, Commands, and Simulation

Today the robot moves, on screen. You write the math that turns a controller stick into a motor speed, write the command that drives the Romi, bind buttons to behaviors, and run it all in the WPILib simulator on a programming laptop.

๐ŸŽฏ Objectives

By the end of this session you will be able to:

  • Trace a stick movement from the controller, through RobotContainer, a command, and a subsystem, to a motor.
  • Write a method that takes a parameter and returns a value, and test it.
  • Write a command class with a constructor, attributes, execute(), end(), and isFinished().
  • Bind a controller button to a command, and explain what a lambda is.
  • Run the robot program in the WPILib simulator, switch modes, and watch motor outputs and dashboard values change.

โœ… Before you arrive

  • Session 3's branch is pushed. Today starts from a fresh main, which already has Sessions 2 and 3 in it.
  • Mentors: solution/session-3 is merged into main.
  • A programming laptop with WPILib 2026 installed, the repository cloned, and an Xbox controller. Mentors set these up. You will share them.

๐Ÿ—“๏ธ Agenda

Time Activity Page
0:00 Recap: subsystems, commands, scheduler. Questions
0:05 The routine in your Codespace: refresh main, branch yourname/session-4 The Routine
0:10 Controllers to motors: the end-to-end path; PWM Spark vs SPARK MAX Controllers to Motors
0:20 Methods with parameters, lambdas, constants Methods and Lambdas
0:30 Exercise part 1: DriveInput passes its tests Exercise: Drive Input
0:40 Exercise part 2: ArcadeDriveCommand and button bindings Exercise: Arcade Drive
0:55 Push, then simulate on a laptop Simulate It
1:15 Wrap up: what Session 5 adds. The challenge is for home Challenge: Turn Around

Mentor pacing note

Part 1 is small on purpose: three methods, tests already written. Keep it to ten minutes so the command and the simulator get the time. If laptops are scarce, have pairs push from their Codespaces and take turns at a laptop while others finish.

๐Ÿงช Exercises

  1. The Routine - refresh main and create yourname/session-4.
  2. Exercise: Drive Input - deadband and sign math, tested.
  3. Exercise: Arcade Drive - the command, the default command, two button bindings, dashboard values.
  4. Simulate It - run it on a laptop with a controller.

๐Ÿ† Challenge (optional)

Turn Around - one button press spins the Romi 180 degrees and stops on its own. A command that finishes, with its numbers in Constants.

๐Ÿ“š Reference

โญ๏ธ Next session

Session 5 adds sensors: encoders and the gyro tell the robot where it is, the numbers go to AdvantageScope, and the code finally runs on the real Romi.